KGRKJGETMRETU895U-589TY5MIGM5JGB5SDFESFREWTGR54TY
Server : Apache/2.2.17 (Unix) mod_ssl/2.2.17 OpenSSL/0.9.8e-fips-rhel5 DAV/2 PHP/5.2.17
System : Linux localhost 2.6.18-419.el5 #1 SMP Fri Feb 24 22:47:42 UTC 2017 x86_64
User : nobody ( 99)
PHP Version : 5.2.17
Disable Function : NONE
Directory :  /proc/21585/root/usr/share/doc/kernel-doc-2.6.18/Documentation/networking/

Upload File :
current_dir [ Writeable ] document_root [ Writeable ]

 

Current File : //proc/21585/root/usr/share/doc/kernel-doc-2.6.18/Documentation/networking/dmfe.txt
Davicom DM9102(A)/DM9132/DM9801 fast ethernet driver for Linux.

This program is free software; you can redistribute it and/or
modify it under the terms of the GNU General   Public License
as published by the Free Software Foundation; either version 2
of the License, or (at your option) any later version.

This program is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
GNU General Public License for more details.


This driver provides kernel support for Davicom DM9102(A)/DM9132/DM9801 ethernet cards ( CNET
10/100 ethernet cards uses Davicom chipset too, so this driver supports CNET cards too ).If you
didn't compile this driver as a module, it will automatically load itself on boot and print a
line similar to :

	dmfe: Davicom DM9xxx net driver, version 1.36.4 (2002-01-17)

If you compiled this driver as a module, you have to load it on boot.You can load it with command :

	insmod dmfe

This way it will autodetect the device mode.This is the suggested way to load the module.Or you can pass
a mode= setting to module while loading, like :

	insmod dmfe mode=0 # Force 10M Half Duplex
	insmod dmfe mode=1 # Force 100M Half Duplex
	insmod dmfe mode=4 # Force 10M Full Duplex
	insmod dmfe mode=5 # Force 100M Full Duplex

Next you should configure your network interface with a command similar to :

	ifconfig eth0 172.22.3.18
                      ^^^^^^^^^^^
		     Your IP Adress

Then you may have to modify the default routing table with command :

	route add default eth0


Now your ethernet card should be up and running.


TODO:

Implement pci_driver::suspend() and pci_driver::resume() power management methods.
Check on 64 bit boxes.
Check and fix on big endian boxes.
Test and make sure PCI latency is now correct for all cases.


Authors:

Sten Wang <sten_wang@davicom.com.tw >   : Original Author
Tobias Ringstrom <tori@unhappy.mine.nu> : Current Maintainer

Contributors:

Marcelo Tosatti <marcelo@conectiva.com.br>
Alan Cox <alan@redhat.com>
Jeff Garzik <jgarzik@pobox.com>
Vojtech Pavlik <vojtech@suse.cz>

Anon7 - 2021